Maybe he didn’t measure the ‘stretch’ on his cylinder fixings ?

I run a 66" Whirlwind 2 blade prop that was suggested by Pete when he ran Jab in the states. I had been offered a 3 blade Warp drive prop from a friend who was upgrading his Rotax powered Kitfox. Pete

I am a Jabiru¨s owner from Spain. Jabiru 2200 (Ref 22A31_ _) In review of 25 hours (400 total hours) we have appreciated movement of the winding. After removing the spider, 3 of the 4 fastening screws

The report looks good with two exceptions that are slightly over average. Nickle was 8 and unit average is 2. I am trying to remember what the cylinder walls are coated with. I seem to remember Nicose

Flew my re-built 2200 last week. Did a post-flight check inside the valve chambers. All had evidence of oil and equal ‘tide’ marks. There is no adjustment to the flow, so is my level typical ? Mick

Good evening all. I have an X’Air Hawk with a Jabiru 2200A hydraulic lifter engine. I assembled this machine in 2009 and it has performed well for350+ hours. During lockoff, lockout or whatever it’s c

I'm going to strip, upgrade and rebuild my early big-fin engine before running it. I'm making a list of upgrades to incorporate. If my through-bolts have undersize threads (nuts rattle on thread), I'l

As we know, it is not possible to get CHTs to exactly match, but we do like to have them reading closer to each other. On my new Gen 4 I have found that numbers 1 and 3 are close to each other by abou

Just saw this outfit mentioned on the Experimental Aircraft and Homebuilder’s group facebook page. Looks like a great option if you want to make multiple identical or precision cut parts. https://send

Don't know if the group is aware of this: http://gsatech.store/hacman-mixture-control-kit/ I thought they were out of business ... Dale

With 70 hours on my replacement 2200 Gen 4 I can already hear the starter throw-over clutch starting to fail. Fortunately I kept the Honda clutch I had put on my failed engine. So I have a replacement

I have an early Hydraulic lifter 2200 s/no: 2246. would appreciate a rundown of what is invloved in converting this to solid lifters, what parts would need replacing and any pitfalls. All the best, ho

Hi Everyone, I'm starting a small partnership in Albuquerque, NM USA and we're buying a BestOff Skyranger with a Jabiru 2200, serial 22A 2294. It's got Relatively low hours on it (has a failed Hobbs,

Found that I had my idle speed screw cranked up too high which did not allow the throttle to be COMPLETELY closed which hinders the choke function. John M

Anyone in U.K. got a spare rubber T piece I can buy ? Mick

Hi group. Hoping for some help. Like Mick. I am just doing a 1000 hour top end on my 2200a s/n 1158. For a long time I had noticed that my flywheel magnets were looking pretty shabby, so while I have

Ready for inspection and check flight. Idling smoothly at 680 RPM !

The following files have been uploaded to the Files area of the main@JabCamit.groups.io group. /determining_moment_of_inertia_experimentally_d02941.pdf By: Jay Scheevel <jay@...> Description: Easy to

No exaggeration, engine started on 1/4 revolution of prop ! Idled at 1200 rpm like a sewing machine. Ran until CHTs were over 100 deg C then shut down. No leaks and then removed valve covers to check

Looking for pitch setting for older sensenich 64” ground adjustable . going on a 3300 sonerai. Any help or suggestions welcome. This message and its attachments may contain legally privileged or confi